HIGH PERFORMANCE COMPLETE DISC BRAKE CONVERSION KIT (FRONT AND REAR WHEEL)+TOOLS

Description

HIGH PERFORMANCE DISC BRAKE CONVERSION KIT
Complete disc brake conversion kit includes:(USD 92)+air mail(USD 63.8) (2-3 weeks)
1x  28/36 spokes rear wheel hub
1x  28/36 spokes front wheel hub
2x Disc brake plate
2x  Callipers
1x Freewheel tool
1x Spoke tool
The callipers has been re-designed so that it can fit in normal bike frame.
If your bike is a disc brake frame like the picture shown below,we have another type of calliper.
You may need the following tools.
Hex wrench
Spanner
Freewheel tool
Spoke tool
Please note.
The diameter of the hub is larger than normal hub,
You may need to use different method to respoke the wheel,e.g.double-cross method.
Or you may need another set of spoke.
How to install this kit:
(Installation takes~1-2hour.)
1. Take out the wheel and remove the freewheel (if any).You may need a bike freewheel tool.
2.Take note of the
original
spoke patterns and note any overlaps
3.Remove the spoke
.
There are spokes on each side of the
wheel
but you should respoke one side at a time for optimal interlacing.
Carefully unscrew the spoke at the rim end and remove the spoke from the flange in the center.
You may need a spoke tools to remove the spoke.
4.Use the wheel hub we provided to respoke the wheel.
5.
Screw the spokes in place but do not tighten yet.
6. After putting back all spokes,make sure to tighten the connections at the flange and the rim for each spoke
. Use the spoke wrench to secure the spokes. Do not over-tighten as this can cause too much tension. The spokes work together, so if one is too tight it can cause problems for the others.
7.Put back the freewheel and screw on the disc plate on the other side.
8.Put the calliper between the bike frame and the hub as shown in the photo.
9.Put on the U ring.
10.Tighten the bolt.
11.Fine tune the position by these two bolts.
DIY disc brake is an enjoyable experience. Make sure you get the suitable tools before the conversion.